ch cha cha changes..

[Bergy]

stiill have funny issues with the pH... still drops and rises exactly .1 at or around the same time the lights come on and off, and the same time the fan comes on and off


http://66.147.240.164/~thelitu5/TLO/graphs.php?period=day7&from=06%2F17%2F2010&to=06%2F21%2F2010&pH2=1&LT1=1&CF1=1


but other then that then pH from the reactor is almost dead on/steady... look at the over variation... and the scale is in the hundreds/thousandths

[psykokid]

at that resolution things are looking good.. if its only shifting that much i think you dont have anything to worry about. Have you added anything to try and bring your CA back up? I see your AWT params show the CA is low.. I have some extra kent liquid CA if you want to give it a go at using that to bring your CA back up to where it should be. Have you installed that BRS media reactor yet so you can get some GFO running to bring down your PO4? If not LMK and i'll come over and give you a hand.

[Bergy]

i havent installed teh gfo yet.. i want to swap out the sump first, otherwise i might have to take the gfo out to take the sump out later on


I had an epidural last week, and this week i have a GI scope thing... Im not sure what to expect from that, but I do know I will be under general anestethics again, so im guessing i will be out of it at least for one day...

my back has gotten bad again, (that epidural was three weeks ago). last weeks epi was on the neck, and it helps the neck, but there is no way for me to ever get the neck and back on the same schedule...

one or the other...


I might try to swap out the sump tomorrow and do a major water change.. that will address the nitrate issue and some of the aLK issue, and get me closer to the baseline...

I will also look at the gfo and make sure i have the pump and connections and plumbing...

but that runs into a different issue.. my shelf thingy on the patio fell apart and i just got it back together but all the stuff is out of order, more then normal...